Are you stuck with a new motherboard and some old hard disk drives? Want to
get some of the data off those old drives but finding the connectors just don't
match up? A bidirectional IDE to SATA convertor could be just what you need, for
using SATA drives on an older IDE based motherboard, or IDE drives on a newer
SATA based motherboard. The unit features support for the maximum IDE data rate
or 150 MB/S, simple installation and compact design to take up minimal room
inside your case. A simple, effective and voluble item to be had in any geeks
arsenal, brought to you at Wholesale-Stars great wholesale prices and able to
shipped direct to you or your customers direct from China.
China Manufacturer Specification
- Supported Transfer Rates: 16.7, 25, 33, 48, 66, 100, 133, 150 MB/S
- Power Source: 5VDC + 12 VDC from Molex PC Power Connector (from Power
Supply Unit of Computer)
- Dimension: 50x4x47mm (LxWxD)
- Manufacturer Ref.: EAGTK5JWTKA6
Other Features:
- Power LED
- No Drivers Needed
- SATA 1.0 Compliant
- Automatic SATA 1.5 Gbps Speed Negotiation (You don't have to turn down the
speed of the other drives on the same SATA controller)
- Support SATA hot plug swapping
- Simple Switch and Jumper Setting for IDE to SATA or SATA to IDE setting
- Support for Partial and Full Sleep Power Management (Dependent on the
Drive/ Operating System/ and Motherboard in use)
- Support for Slave mode
- Ultra Low Power Consumption
Accessories:
- SATA Data Cable
- Power Supply Cable (Requires 1 Molex Connector from PS Power Supply
- Manufacturer and Origin: China
Even lower prices available for you if you're ordering in
larger wholesale quantities. Get your samples first then contact us for your
personal discount quotes!
If you wish to make comments or reviews about this product, please use the
product review. Please open a enquiry ticket if you have questions.
This product was added to our catalog on Tuesday 01 July, 2008.
